In Miami, air handlers run most of the year, so a clogged condensate drain or a cracked drip pan is a common way clean water ends up in a closet, a ceiling or along a baseboard. The fix starts with shutting the unit down, finding how far the water spread, and drying wet materials within 24 to 48 hours.

Why this leak is so common here
A central air conditioner removes humidity from indoor air and sends that water down a condensate line, usually into a trap and then outdoors or to a drain. When algae, dust or a kink blocks the line, water backs up into the pan under the air handler. If the pan overflows, or if the pan itself is cracked, the water has nowhere to go but into the closet, through the ceiling below, or across a slab.
South Florida homes often keep the air handler in a tight closet or in an attic over living space. A slow overflow can run for hours or days before anyone notices a stain. By then the water has often wicked into drywall, baseboards and, on a slab house, into the edges of tile or vinyl plank.
Signs that the drain, not a supply line, is the source
- A tan or gray stain on the closet floor, the ceiling below the unit, or the wall beside the air handler.
- A musty smell in the closet even when the rest of the house smells fine.
- The system short-cycling, or not staying on, because a float switch in the pan has shut it off. That switch is a safety device, not a repair.
- Water in the pan, or a wet, slimy condensate line, when you look at the unit with the power off.
These clues point to condensate, which the IICRC S500 standard treats as Category 1, or clean, water so long as it has not sat long enough to pick up contaminants from building materials or a dirty pan. Category can change if the water sits or mixes with other sources. The person who inspects the loss should confirm the category before anyone decides what can be dried in place.
Safe first steps
- Turn the system off at the thermostat and, if you can do it safely, at the breaker. Do not keep running a unit that is overflowing. You will pump more water into the house.
- Stop additional flow. If a float switch has not already cut the power, switching the unit off does the same job.
- Stay out of standing water if it has reached outlets, the air handler, or a wet electrical panel. Call for help instead of reaching into a wet closet.
- Photograph the pan, the stain, the ceiling below, and any wet flooring before you move things or mop. Those pictures help an insurer see where the water started.
- Mop or extract what you can see, then pull wet rugs and saturated boxes out of the closet so they stop feeding moisture back into the walls.
A towel on the floor is not drying. Water in a slab, in thinset, or inside a wall cavity stays there until it is measured and removed with the right equipment.
Why a "small" overflow still needs a real dry-out
The EPA advises drying water-damaged materials within 24 to 48 hours to help prevent mold growth. In a humid climate, that window is easy to miss if the only step is mopping the closet. Drywall that feels dry on the face can still be wet at the base or inside the cavity. Tile over a wet slab can trap moisture for a long time.
A provider will usually:
- Confirm the source has been stopped.
- Map moisture in walls, trim and the slab with a meter, not just a hand test.
- Extract standing water and set air movers and dehumidifiers to pull moisture out of materials.
- Keep a written log of readings until the materials reach a dry standard, which is also the record an insurer often wants to see.
The water removal cost estimator uses this site's pricing rates: $4–$6 per square foot for Category 1 extraction and drying. A clean overflow found quickly often lands in the $450–$1,500 band; a closet leak that soaked a ceiling and the room below is more often a Typical job at $1,500–$5,000. Those are planning ranges, not quotes.
When to call for help
Call if water reached drywall, insulation, a ceiling, or flooring that sits on a slab, or if the overflow may have been running for more than a day. The water damage restoration page explains the usual order of work. For houses in Kendall and nearby unincorporated areas, where air handlers in closets and attics are common, the Kendall area page covers local housing and flood notes.
This site is an independent referral service. If you send a request, one local provider may contact you about your home.
FAQs
Is AC condensate considered clean water?
Usually, yes, when it first overflows. IICRC S500 treats condensate as Category 1 if it has not been contaminated. Standing water in a dirty pan, or water that sat in building materials, can be reclassified. Ask the inspector to say which category they are using and why.
Can I just clear the drain and turn the unit back on?
Clearing the line stops new water, which is necessary, but it does not dry what already soaked into drywall, trim or a slab. If materials stay wet past 24 to 48 hours, the mold risk rises even after the drip has stopped.
Why did my air conditioner stop on its own?
Many pans have a float switch that shuts the system off when water rises. That is a warning, not a completed repair. Find the blockage or the crack, then dry whatever the overflow already reached.
Will homeowners insurance pay for this?
A sudden overflow from a clogged line or a failed pan is often reviewed as an accidental discharge, but every policy is different and wear-and-tear exclusions can apply. Photograph the source and the damage, and ask your insurer. This site cannot decide coverage.
Sources
- EPA, A Brief Guide to Mold, Moisture and Your Home.
- IICRC, ANSI/IICRC S500 Standard for Professional Water Damage Restoration.
- Planning rates: this site's pricing page, drawn from HomeGuide extraction-and-drying figures.